Inductrix clone build -

Decided to change the frame on the E010S as it has a couple of cracked motor mountings.  Nothing that super glue has not fixed, but wanted it to look nicer.  Bought a stock frame for the E010S...the battery holder area is larger than the Blade version of the frame.  I also bought a could of frame stiffeners, just the plastic X type that hold each motor bay.

So, during that purchase...also bought some SpinTech motors, 6 of them (3 CW and 3 CCW) which means a $5 discount if you purchase a frame as well...so I did that too.

Figured the FC has been bounced around a bit and it would be fun to have TWO micros, and another frame coming so need another FC - Acrowhoop V2.

So everything shows up yesterday (on a Friday!) and 2 micros have now been built and are flying.



I had only a single camera and that one is, unfortunately, no longer function...so LOS flight for right now, but a new one is on the way.

Have to say that I am impressed with the SpinTech motors.  Very quiet and smooth.  I have used the "stock" red motors (loud) and 2 different sets of Lumenier's (noticably noisy, but a smooth noise) and these are the quietest brushed 6mm motors so far.

Also, the new FC is in the E010 frame and not the SpinTech frame.  I like the ducted design better than the open one.