Clik here to view.
250 HK Ghost Edition - my first build
Hi I used to build parkjets and fixedwings (F22, SR71, SU37) also flew some dji products for some Arial photography jobs (phantom and S1000), now i'm stuck with these mini quads for sometime and i...
View ArticleSetting up VBAT
Hello guys, I've been in the process of doing my first 250 build and i'm currently getting ready to install a VBAT connection to my Naze 32 (full). I've looked at videos of Painless360 and he was using...
View ArticleVTX is 12V Camera is 5V, Where to connect LC Filter?
Hi, My VTX is 12V powering it from the PDB that have BEC for 5V output which i used to power the camera I've connected the lc filter before the VTX but i'm still having these annoying lines while flying.
View ArticleNeed a lot of help with sons science fair project... wireless robotic hand
First I would like to say I saw this type of tx/rx DIY here: http://blog.oscarliang.net/diy-wireless-...for-robots Well, I am new to all of this. I can code a little, but it has been a while, and I am...
View Articleupgrading memory chip on Naze32
Following your blog post I replaced the 2mb chip on my naze32 rev6 with a 16mb. Cleanflight sees 16mb but there are 2 problems. 1. the logs do not store if powered off 2. the logs are corrupt and not...
View ArticleFPVFreerider and Taranis
Hi Folks.... While I am building my first quad, I thought it would be prudent to fly on a simulator to get some practice. While I realize that a simulator can only come so close to the real thing, it's...
View Article180° turn vibration
Hi, When doing a hard 180° stop'n go turn I get som vibrations. What to do to smooth them out? Increase D on R and Y? Fpv camera at 45° so I use both R and Y when turning. Using betaflight 2.5.3 mw23,...
View ArticleNeed some help with Matek 5 in 1 PDB setup
So I have a new build going and am using the Matek 5 in 1 PDB. I can power up with a 3s battery and the ESCs all power up just fine. However, when I connect the wires from the PDB (signal, hot, and...
View ArticleClik here to view.
Lumenier 4Power Quick Swap PDB
The Quick Swap PDB enables solder-less arm connections with ESC power being routed into specially designed power taps and the ESC Servo connection being made available on the side underneath the power...
View ArticleVoltage Alarm when going Full throttle
Do you guys know why my low voltage alarm beeps everytime I go full throttle? I'm using fairly new batteries. It happens even when the battery is fully charged. What causes this? I am flying 40-80c...
View ArticleClik here to view.
How-to: Fixing Yaw Drift
Saw this on FB thought it would be useful so sharing it, credit to Joe. So here it is. Just a quick run-down on how to correct yaw drift issue. Steps apply to CleanFlight and BetaFlight-enabled FCs....
View ArticleClik here to view.
Red rotor OSD PDB
Just received my RED Rotor OSD PDB It's pretty easy to connect: camera goes in , and on the other side to the VTX. Both get power from the PDB, aswell is there a 5V output for the Naze32. Keep in...
View ArticleClik here to view.
Power Distribution Boards
Just thought I would write a little something about PDB's. They come in all sizes and flavours, with each manufacturer claiming theirs is better than everyone else's. So, do you actually need a PDB ?...
View ArticleBaterry Change Problems
Every time I change batteries on my quad I get erratic flying and uncontrolled takeoff. What do I have to do to solve this problem. Frustrating
View Article+1 Reputation - Thanks!
First off, Thank you to those of you that gave me my first three +1 Reputation today. I appreciate that my taking the time to contribute back to the community is appreciated! Thank you that you cared...
View ArticleClik here to view.
Thread Rating Question
I looked, but as of yet haven't found what is the purpose of "thread" rating with the 1 to 5 stars? Does someone have some insight as to the purpose and usefulness of this feature? Think I found my own...
View ArticleClik here to view.
Runcam Swift FPV Camera
Runcam is releasing a new fpv cam that can match the HS1177 in terms of size, but with greater performance. It's essentially the same camera as the Runcam SkyPlus, but smaller. Dimension: 26mm x 26mm...
View ArticleClik here to view.
Tried Fitting A Black Box
So i fitted my quad with a blackbox but i am unsure on how you get the data off it???? Any Helps Appreciated
View Articlequad won't fly straight, out of sync esc?
Hey Folks, I could really use your help. I'm running betaflight on a cc3d board. I was finally able to flash my esc with blheli 14.4 These are the esc's I have:...
View ArticleHi and Hello and Welcome
There's no introduction forum!!??? What!!??? Anyway, I saw Oscar post a link to this forum on the FB group and I immediately joined. Might be old news to some of you but I'm usually so busy it's hard...
View Article